SOLUTION TO THE PROBLEM OF LAMINATING MACHINE

　　During the laminating process of the laminating machine, there will be some problems, so how to solve the problems in the process?

　　 A large area of the screen has a feeling of "mist and misty"

　　1. Insufficient film pressure-adjust the pressure of the cold laminator;

　　2. The two ends of the cold laminating machine are not flat-adjust the adjustment screws of the cold laminating machine spacing to achieve an equal distance;

　　3. When this happens when passing the photo paper-the surface of the photo paper is not flat, generally around 25 degrees, and it will automatically disappear after 2-3 hours. The higher the temperature, the faster it will disappear;

　　4. This situation occurs when the PP adhesive is used-A. If there is no "rough" feeling in the PP adhesive picture by hand, please follow the above method; B. If there is a "rough" feeling, you need to replace the PP adhesive;

　　5. Glue viscosity is not good at low temperatures-A. Increase the use environment temperature. B. Replace the cold laminating film.

　　There are "white spots" after the screen

　　1. Insufficient glue viscosity-A. Increase the use environment temperature;

　　2. The glue is thin-generally the distance is not long, and the probability of occurrence before and after the shutdown is relatively large, generally just a few meters away;

　　3. The PP adhesive surface feels "rough" when touched by hand-A. Replace the PP adhesive, B. Or use a photo studio film to pass the picture;

　　4. There is dust in the air-A. Purify the operating environment, B. Turn off the source of blowing or air intake;

　　5. Water droplets (such as saliva) are accidentally splashed on the surface of the spray painting-A. Pay attention to the operation, especially do not face the screen when speaking, B. The air temperature in a dry environment, such as: turn on the air conditioner, hot air blower or ventilation, etc.

　　It is good after painting, but there are "bubbles" after being left for a period of time (or the next day)

　　1. The glue is not "cured" thoroughly, open the cold-laminated film package and place it in the air for 2-5 days, so that the glue can be fully "cured" under natural conditions;

　　2. The picture is not sufficiently dry, especially in winter, because the ink in winter contains antifreeze ingredients, which is not easy to volatilize and completely dry the picture. Generally, the storage time in winter is twice as long as summer and autumn.

　　The above are some of the problems in the laminating process of the laminating machine and the corresponding solutions. If you feel good, you can collect it!